"E-Ride Pro SS 72V" covers two bikes: the SS 2.0 (72V 40Ah, 12 kW peak) and the SS 3.0 (72V 50Ah, 15.8 kW peak). Either way, a lot of what makes the bike feel dialed has nothing to do with buying a new controller. Here's how to tune what you already have, and when it's worth spending money.
Heads up: E-Ride Pro no longer makes the SS 2.0. We have a few left in stock, and this still applies if you already own one. Buying new? The SS 3.0 and 4.0 are the current models.
Know Your Baseline
| SS 2.0 | SS 3.0 | |
|---|---|---|
| Power | 5 kW rated / 12 kW peak | 6 kW rated / 15.8 kW peak |
| Battery | 72V 40Ah (2,880 Wh) | 72V 50Ah (3,600 Wh) |
| Top speed | 60 mph | 62 mph |
| Tires | 70/100-19 F, 80/100-19 R | 2.75-19 F, 3.00-18 R |
| Weight | 152 lb | 167 lb |
Both models have regenerative braking and multiple ride modes (ECO, Sport and Turbo on the SS 2.0).
1. Use the Ride Modes on Purpose
The cheapest tune is picking the right mode. ECO softens the throttle and stretches range, and it's the best mode for tight, slippery or technical trail. Save the top mode for open sections. A lot of riders who think the bike is "too twitchy" are just riding in the wrong mode.
2. Set Your Sag
Stock suspension is set up for an average rider. If you're much heavier or lighter, the bike will feel harsh or wallowy until you adjust preload. Set rear sag with a helper and a tape measure, then adjust compression and rebound (if your shock has clickers) a couple of clicks at a time. Change one thing, ride the same section, and note what changed.
When you've outgrown stock, the EXT Arma MX Rear Shock is a direct bolt-on for the SS 1.0/2.0/3.0. More in shocks and forks.
3. Tire Pressure
Pressure changes grip more than most people expect. Lower pressure gives more traction on rocks and roots, but go too low and you risk pinch flats and rim damage. Start in the middle of the range printed on your tire and drop a little at a time. A real dirt tire in your size from our tires collection is one of the best grip upgrades per dollar.
4. Gearing
Sprocket changes are the easiest way to change how power comes on:
- Bigger rear sprocket: harder launches and climbing, lower top speed.
- Smaller rear sprocket: higher top speed, softer launch.
Any time you change gearing, recheck chain length and tension. SS 3.0 owners can run the EBMX 48T sprocket for the SR/3.0. Browse sprockets and chains.
5. Brakes That Match the Power
Before you add power, make sure you can stop. Bleed the brakes if the lever feels soft, and replace pads before they're metal-on-metal. For a real upgrade, there are moto-style conversion kits for both models:
- EBike Garage Moto Brake Conversion Kit for the S / SS 2.0
- EBike Garage Moto Brake Conversion Kit for the SS 3.0 / SR
6. Controller Upgrade: The Big One
An aftermarket controller is where the real power gains are. The EBMX X-9000 V3 lets you program throttle response, power output and regen. Things to know:
- Do it after brakes and suspension. More power makes every weak point worse.
- Older SS 2.0 bikes with the original (V2) battery connector need the EBMX X-9000 E-Ride Pro V2 Battery Harness.
- Make changes in small steps and watch motor and controller heat on test rides.
- Controller and motor changes can affect your warranty. Check before you modify.
7. Maintenance After Tuning
More power means more wear. Check chain tension and wear, brake pads and bolt torque more often, especially on the motor mounts, swingarm and linkage. The maintenance collection has the basics, and good riding gear is in our protection collection.
FAQ
What does "SS 72V" mean?
It refers to the E-Ride Pro SS, which runs a 72V battery. Current models are the SS 2.0 and SS 3.0.
Do I need a new controller before a new motor?
Generally yes. The controller decides how much power the motor gets. Talk to us before mixing parts so the motor and controller are matched.
What's the best first tune?
Set your sag and tire pressure. It's free and makes a bigger difference than most bolt-ons.
Not sure what fits your bike? Our support team is made up of real riders. Email support@tbelectricmoto.com. Shop parts in the E-Ride Pro SS 1.0/2.0 and SS 3.0 collections.

